Description
- Strap end detection with ejection of the remaining strap
- Automatic strap loop ejection
- Dispenser with bayonet closure
- Direct current drive of the unit by wear-free direct drives
- Wear-free, controlled strap track system
- Adjustable roller actuation with frequency controlled motor
- Adjustable strap distances
- PLC control Siemens type S7
- Touch panel for optic operating instructions, troubles shooting guide, etc.
- Heat-weld sealing system with electronic temperature controls
- Permanent strapping counter
- Dry contact relay for up-stream and down-stream systems
- Adjustable conveyor table height from 800-900 mm
- Structural coating RAL 5010, gentian blue

Variants & Options
- Pneumatical single or double press
- Pneumatical side pusher
- Traffic light warning system or acustic malfunction signal
- Narrow sealing unit (on request)
- Ethernet- / Profi-Bus-connection
- Special coating according to RAL scale
- Stainless-steel versions

Technical details

Capacity:
approx.. 30 bundles/ minute at a conveying speed of 0.6 m/s

Straps:
PP-strap 5-12 mm

Strap coil dispenser:
Core diameter: 200 mm
Core width: 190 mm

Electricity:
Network data: 400 (415, 440), 50/60 Hz, 3PH
Power consumption: approx. 1.9 kW

Pneumatics:
Mains pressure: 6 bar (1/4 inch fast clutch)

Consumption at 25 cycles/ minute:

Hold-down device: 130 l/min.
Back stop: 70 l/ min.

Weight:
~538 kg (1650 x 600 mm, with hold-down device)
~640 kg (1650 x 600 mm, with hold-down device and backstop)